TDF Duct

What is TDF Duct?

TDF stands for Transverse Duct Flange. It’s a type of flange used at the ends of duct sections to connect them together. Instead of using traditional methods like welding or using separate flange pieces, TDF ductwork has the flange formed directly onto the duct during the manufacturing process. This makes the installation process quicker and can provide a more airtight seal.

Components of TDF Ducts

1. Duct Sections: These are the actual lengths of duct that transport air throughout the HVAC system. They can be rectangular, square, or sometimes round.

2. Integral Flanges: The key feature of TDF ducts is that the flanges are formed as part of the duct itself. These flanges are on all four sides of the duct ends and have specific profiles that allow them to mate with each other securely.

3. Corner Pieces: These are inserted into the corners of the flanges. They provide additional strength and ensure a tight seal at the corners where the duct sections meet.

4. Clips or Cleats: Once the duct sections are brought together, clips or cleats are used to secure the flanges. These hold the flanges tightly, ensuring there’s no movement and maintaining an airtight connection.

5. Sealant or Gaskets: To ensure no air leaks, a sealant or gasket is often applied between the flanges before they are clipped together. This provides an extra layer of protection against leaks.

6. Fasteners: Screws or bolts are sometimes used to further secure the corners and ensure the ducts stay connected.

Advantages of TDF Ducts

• Quick Installation: Since the flanges are already part of the duct, you save time on assembly.
• Cost-Effective: Less labor and fewer materials are needed compared to traditional flange systems.
• Good Sealing: The integrated design and use of gaskets or sealants help prevent air leaks.
• Structural Integrity: The corner pieces and cleats provide good strength, ensuring the duct sections stay securely connected.

How TDF Ducts Are Installed

1. Preparation: Start by ensuring all duct sections are cut to the correct length and the flanges are formed properly.

2. Sealing: Apply a bead of sealant or place a gasket along the flange edges if needed.

3. Alignment: Bring the duct sections together, aligning the flanges so that they mate properly.

4. Corner Pieces: Insert the corner pieces into the flanges. This might require a bit of force to ensure they fit snugly.

5. Clipping: Use the cleats or clips to lock the flanges together. This is typically done along the length of the flange on all sides.

6. Fastening: If needed, add screws or bolts at the corners for additional security.

7. Inspection: Finally, check all connections to make sure they are secure and airtight.